When a flat roof in Wisbech starts leaking, knowing what to do in the hours between spotting the problem and getting a roofer on site can prevent a manageable repair from turning into a much bigger one.
Call any time. Calls are answered day and night and passed straight to our roofers.
A flat roof failure rarely announces itself at a convenient moment. Leaks tend to appear during heavy rain, often late in the day or over a weekend. Getting a roofer on site immediately is not always possible, and in that window - which might be a few hours or a few days - the decisions you make inside the property can limit the damage considerably. Equally, certain things that might seem helpful can actually make the problem worse. This page covers both: what to do while you wait, and what to leave alone until a professional can assess it.
Flat roofs in Wisbech and the surrounding area are most commonly installed on garages, single-storey extensions, and outbuildings. The surface membrane is usually either torch-on felt or EPDM rubber, though older properties may still have traditional built-up bitumen felt that was laid many years ago.
When a flat roof leaks, it is not always the membrane itself that has failed. Common causes include lifted or cracked flashings at the edges and wall junctions, blocked outlets causing water to pond and eventually force its way in, splits at seams in the felt, or punctures in EPDM membrane caused by debris. The actual point of water entry on the roof is often some distance from where the leak appears on the ceiling below, because water travels along joists and rafters before it finds a way through.
The priority inside the building is to protect your possessions and, where possible, prevent water damage spreading to walls and ceilings below. Here is what to do while you wait for the roofer:
The urge to fix things immediately is natural, particularly if rain is still coming in. But a number of actions that seem helpful can cause problems that are more costly than the original leak.
Do not go onto the roof during active rain or wind. A wet flat roof surface is slippery, regardless of whether it is felt or EPDM rubber. Falls from flat roof level cause serious injuries. Wait for dry, calm conditions and proper access equipment before anyone goes up.
Do not apply sealant or mastic tape without a professional assessment. Over-the-counter sealants and self-adhesive repair tapes are sold as temporary fixes. The problem is that they are often applied without knowing what the actual cause of the leak is. Sealing over a symptom - a crack in the surface, a suspicious-looking seam - while the real entry point remains unaddressed means the leak continues, but may now be harder to trace. Sealant applied to a wet or dirty surface also fails to bond properly and peels away quickly.
Do not assume the leak is directly below the wet patch on the ceiling. Water entering a roof travels horizontally along timbers before it drops through. Probing or cutting the ceiling in the wet area will not reveal the entry point and adds unnecessary repair work.
Do not attempt to pull back the membrane. Lifting a section of felt or EPDM without the correct tools and knowledge can create additional openings and make the initial repair more complex.
Do not use a garden hose to find the leak. Running water onto the roof to try to recreate the leak and trace it sounds logical but rarely works - it introduces more water into an already compromised system and can spread moisture into the deck.
There are a small number of steps that are genuinely helpful in limiting damage until a roofer can attend. If you have safe access to the roof via a Velux or flat section that is reachable without ladders, a heavy-duty polythene tarpaulin weighted down at the edges can reduce the amount of water entering. The tarpaulin should be large enough to overlap the edges and must be secured against wind movement - a loose tarpaulin in wind can cause more damage than the leak itself.
If the leak appears to be coming from a blocked drainage outlet - you can see water ponding visibly around the outlet from a safe vantage point - and you can reach the outlet safely without walking on the membrane, clearing the blockage will immediately reduce the hydrostatic pressure on the roof surface. Use a gloved hand or a piece of stiff wire to clear leaves and debris from the outlet, and check that the downpipe below is also clear.
Understanding what a proper flat roof inspection involves helps you ask the right questions when a roofer comes to the job. A thorough inspection includes checking the full perimeter of the roof - the flashings, upstands, and wall junctions - as well as the drainage outlets, the condition of the membrane surface, and, where possible, the integrity of the deck below. The roofer should be able to tell you where water is entering, what has caused it, and what the options are for repair or replacement.
Be cautious of any roofer who gives you a firm price immediately on arrival without first identifying the source of the leak. A problem that looks like a simple surface split may have caused deck damage below, which changes both the repair method and the cost. A roofer who identifies all of the issues before quoting will give you a more accurate price and a longer-lasting fix.
Ask specifically whether the deck will be inspected as part of the repair. On torch-on felt roofs, the roofer may need to lift a small section to check the boards beneath. On EPDM roofs, soft spots in the membrane when walked on can indicate wet or rotted decking below.
When the immediate crisis is resolved and you are deciding what to do about the roof itself, the choice is usually between a targeted repair and a full replacement. EPDM rubber and torch-on felt are common flat roofing systems. EPDM is cold-applied and highly flexible, making it straightforward to repair with compatible adhesive patches and resistant to the freeze-thaw cycles that cause older felt to crack. Torch-on felt is a well-established and cost-effective system for straightforward flat roofs when properly installed.
Full replacement of a typical garage roof of around 20 square metres runs from approximately £1,400 to £2,000 for EPDM, depending on deck condition and access. Always get a written quote that specifies the membrane system, the deck allowance, and how drainage will be handled.
Downham Market Roofers carry out flat roof repairs and full installations for homeowners in Wisbech and the surrounding area. Call us to arrange a flat roof survey and get a clear, written assessment of what your roof needs.
No obligation · We'll call you to arrange a free visit
Call any time. Calls are answered day and night and passed straight to our roofers.